I used this part to fix my Jenn-Air microwave. Works great! Plus I have a spare!
It wasn't an exact fit, but I made it fit easy enough (it's a little bigger, bending the mounting tabs got it to fit). It has the same cut-off temperature as the original, so it is perfect. Plus I saved at least $25 as the OEM piece is significantly marked up. While I waited for the part, I put a jumper over the thermostat. The thermostat was located over the magnetron. I knew the thermostat was the problem as the ohm reading was higher than near zero. Plus I checked the magnetron to make sure it wasn't getting too hot.
No comments:
Post a Comment